Fairbanks FB2550 DAT SERIES DRIVER ACCESS TERMINAL - Manual (Page 99)

Section 5: Accessories
2/2013 99 51303 Rev. 1
6.2. PROGRAMMING THE TRAFFIC LIGHT CONTROL
The TRAFFIC LIGHT CONTROL shows the status of the scale’s traffic light. It
is typically controlled automatically by the instrument weighment cycle.
 The light has a manual override using the touch screen on the main weighing
display.
 Each of the two (2) I/O RELAY CARDS supports two (2) sets of lights,
totaling four (4) Stop Light Units.
Follow these steps to configure the
Traffic Light Control.
1. Using an external keyboard, press
2. ALT + HOME .
3. Select LOGIN .
4. Enter the Supervisor Password.
5. Open the CONFIGURATION MENU .
6. Press PAGE FORWARD twice.
7. Select TRAFFIC LIGHT CONTROL .
8. Select SCALE ID X TRAFFIC
CONTROLS .