IDEC MicroSmart Pentra User Manual
Page 22
2: M
ODULE
S
PECIFICATIONS
2-6
W
EB
S
ERVER
CPU M
ODULE
U
SER
’
S
M
ANUAL
FC9Y-B1278
Note 1: Select program capacity of 62,400 bytes or 127,800 bytes. When 127,800 bytes is selected, the run-time program download
cannot be used.
Note 2: The maximum number of outputs that can be turned on simultaneously is 54.
Note 3: Among the additional I/O modules, the maximum number of outputs that can be turned on simultaneously is 54.
System Statuses at Stop, Reset, and Restart
Note: All expansion data registers are keep types.
Communication Function
Note 1: To use the USB port, USB driver must be installed on the PC. For the procedure to install the driver, refer to "USB Driver
Installation Procedure" on page A-3.
Note 2: A USB maintenance cable (HG9Z-XCM42) and a USB Mini-B extension cable (HG9Z-XCE21) are available as optional accessories.
For instructions on using the USB extension cable, refer to "Securing USB Extension Cable Using Cable Tie" on page 3-5.
Note 3: Communication modules that can be connected to port 2 are listed in the following table.
Analog Voltage Input
Quantity:
Input voltage range:
Input impedance:
Data range:
1 point
0 to 10V DC
Approx. 100 k
Ω
0 to 255 (8 bits)
Pulse Output
3 points
Maximum frequency: 100 kHz
Communication Port
Communication connector for port 2
Cartridge Connector
2 points for connecting a memory cartridge (32KB, 64KB, or 128KB) and a clock cartridge
Mode
Output
Internal Relay, Shift Register, Counter,
Data Register, Expansion DR, Extra DR
Timer Current Value
Keep Type
Clear Type
Run
Operating
Operating
Operating
Operating
Stop (Stop input ON)
OFF
Unchanged
Unchanged
Unchanged
Reset (Reset input ON)
OFF
OFF/Reset to zero
OFF/Reset to zero
Reset to zero
Restart
Unchanged
Unchanged
OFF/Reset to zero
Reset to preset
CPU Module
FC5A-D12K1E
FC5A-D12S1E
USB
Function
Maintenance Communication (Note 1)
Cable
USB cable from the third party (A connector to Mini-B connector) (Note 2)
Isolation between Internal Circuit
and Communication Port
Not isolated
USB Type
USB Mini-B
USB Standard
USB 2.0
Ethernet
Electrical Characteristics
IEEE 802.3 compliant
Transmission Speed
10BASE-T, 100BASE-TX
Function
Maintenance communication, user communication, Modbus TCP
communication, e-mail, Web server
Recommended Cable
CAT. 5 STP
Isolation between Internal Circuit
and Communication Port
Pulse transformer isolated
User Web Data Storage
FROM
User Web Data Capacity
1MB
Port 2 (Optional) (Note 3)
Possible