IDEC MicroSmart Pentra - Manual (Page 5)

W EB S ERVER CPU M ODULE U SER ’ S M ANUAL FC9Y-B1278 P REFACE -3
About This Manual
This user’s manual primarily describes entire functions, installation, and programming of the Web server CPU modules.
Also included are powerful communications of the Web server CPU module and troubleshooting procedures.
Chapter 1: General Information
General information about features, brief description on special functions, and various system setup configurations for
communication for the Web server CPU module.
Chapter 2: Module Specifications
Specifications of the Web server CPU module.
Chapter 3: Installation and Wiring
Methods and precautions for installing and wiring the Web server CPU module.
Chapter 4: Operation Basics
General information about setting up the Web server CPU module for programming, starting and stopping MicroSmart
operation, and simple operating procedures from creating a user program using WindLDR on a PC to monitoring the
MicroSmart operation.
Chapter 5: Function Area Settings
Program capacity selection, watchdog timer, network settings, SNTP server, and connection settings.
Chapter 6: Remote Host List
Detailed description on remote host list.
Chapter 7 through 9:
Various communication functions such as maintenance communication, user communication, and Modbus TCP
communication.
Chapter 10: E-mail
Detailed description on configurations and procedure to configure e-mail function in WindLDR.
Chapter 11: PING Instruction
Detailed description on PING instruction.
Chapter 12: Web Server
Detailed descriptions on Web server function and system library for user’s web pages.
Chapter 13: Troubleshooting
Procedures to determine the cause of trouble and actions to be taken when any trouble occurs while operating the
MicroSmart.
Appendix
Additional information about CGI of Web server and the procedure to install USB driver.
Index
Alphabetical listing of key words.
IMPORTANT INFORMATION
Under no circumstances shall IDEC Corporation be held liable or responsible for indirect or consequential damages
resulting from the use of or the application of IDEC PLC components, individually or in combination with other
equipment.
All persons using these components must be willing to accept responsibility for choosing the correct component to
suit their application and for choosing an application appropriate for the component, individually or in combination
with other equipment.
All diagrams and examples in this manual are for illustrative purposes only. In no way does including these diagrams
and examples in this manual constitute a guarantee as to their suitability for any specific application. To test and
approve all programs, prior to installation, is the responsibility of the end user.