IDEC MicroSmart Pentra - Manual (Page 38)

3: I NSTALLATION AND W IRING
3-10 W EB S ERVER CPU M ODULE U SER ’ S M ANUAL FC9Y-B1278
Removing the Communication Connector Cover
Before mounting a communication module or HMI base
module next to the slim type CPU module, the
communication connector cover must be removed from
the CPU module. Break the communication connector
cover on the slim type CPU module as described below.
1. Carefully push in the communication connector cover at position (1) to break bridges A as shown in either figure
below.
2. The other end (2) of the communication connector cover will come out as shown at left below. Push in this end.
3. Then, the opposite end (3) will come out. If the end does not come out, insert a thin screwdriver into the gap and
pull out the end (3).
Hold the communication connector cover at (3), and pull off the communication connector cover to break bridges B.
• When using a thin screwdriver to pull out the communication connector cover, insert the screwdriver
carefully and do not damage the electronic parts inside the CPU module.
• When first pushing in the communication connector cover to break, take care not to injure your finger.
Caution
Bridges B
Bridges A
Communication
Connector Cover
(1)
(2)
(3)