Mounting on din rail, Mounting on din rail -6 – IDEC MicroSmart Pentra User Manual
Page 34
3: I
NSTALLATION
AND
W
IRING
3-6
W
EB
S
ERVER
CPU M
ODULE
U
SER
’
S
M
ANUAL
FC9Y-B1278
Mounting on DIN Rail
Removing from DIN Rail
Direct Mounting on Panel Surface
1.
Fasten the DIN rail to a panel using screws firmly.
2.
Pull out the clamp from each Web server CPU
module, and put the groove of the module on the
DIN rail. Press the modules towards the DIN rail and
push in the clamps as shown on the right.
3.
Use BNL6 end clips on both sides of the Web server
CPU modules to prevent moving sideways.
• Install the Web server CPU modules according to instructions described in this user’s manual. Improper
installation will result in falling, failure, or malfunction of the Web server CPU module.
• Mount the Web server CPU modules on a 35-mm-wide DIN rail or a panel surface.
Applicable DIN rail: IDEC’s BAA1000PN10 or BAP1000PN10 (1000mm/39.4” long)
Caution
Groove
35-mm-wide DIN Rail
Clamp
1.
Insert a flat screwdriver into the slot in the clamp.
2.
Pull out the clamps from the modules.
3.
Turn the Web server CPU modules bottom out.
35-mm-wide DIN Rail
Clamp
Web server CPU modules can also be mounted on a
panel surface inside a console. When mounting a slim
type CPU module, digital I/O module, analog I/O
module, HMI base module, or communication module,
use optional direct mounting strip FC4A-PSP1P as
described below.
Installing the Direct Mounting Strip
1.
Remove the clamp from the module by pushing the
clamp inward.
2.
Insert the direct mounting strip into the slot where
the clamp has been removed (A). Further insert the
direct mounting strip until the hook enters into the
recess in the module (B).
(B)
(A)
Direct Mounting Strip
FC4A-PSP1P