Removing the hmi module, Removing the hmi module -4 – IDEC MicroSmart Pentra User Manual
Page 32
3: I
NSTALLATION
AND
W
IRING
3-4
W
EB
S
ERVER
CPU M
ODULE
U
SER
’
S
M
ANUAL
FC9Y-B1278
Removing the HMI Module
This section describes the procedures for removing the HMI module from the optional HMI base module mounted next
to any slim type CPU module.
1.
Insert a thin flat screwdriver (ø3.0 mm maximum)
between the gap on top of the HMI module until the
tip of the screwdriver bottoms.
2.
While turning the screwdriver in the direction as
shown, disengage the latch on the HMI module and
pull out the HMI module.
3.
Remove the HMI module from the HMI base module.
• Turn off the power to the Web server CPU module before installing or removing the HMI module to
prevent electrical shocks.
• Do not touch the connector pins with hand, otherwise electrostatic discharge may damage the internal
elements.
Caution
Latch