Yokogawa PC-Based MX100 - Manual (Page 37)

1-28 IM MX100-01E
1.9 Functions of the 8-CH, Medium-Speed Analog
Output Module
This module is equipped with 8 outputs that can output voltage or current. An external
power source (24 V) is required for current output. For voltage output only, an external
power source is not required.
Input terminal (clamp terminal)
Terminal cover
Output Type
Transmission output: Outputs a voltage or current corresponding to the measured results
of the input channel specified on the same unit.
User output: The specified value is output based on the value sent from the PC
software. Transmission output of computation channel data or of
data from separate units is available.
Output Range
Voltage: –10.000 V to 10.000 V
Current: 0.000 mA to 20.000 mA
Output Update Interval
The output is updated every 100 ms (minimum). It is not synchronized to the
measurement interval.
Operation When Errors Occur upon Startup
See section 1.11.
Output Operation During Calibration
Calibration Status Output Status
Channels being calibrated User output (output of calibration value)
Calibrated channels Holds the last calibration user output value*
Non-calibrated channels Holds the output value (holds the last output value during
steady operation (see section 1.11))
* Holds the last calibration user output value until the next output update.