Yokogawa PC-Based MX100 - Manual (Page 46)

2-1
IM MX100-01E
Installation and W
iring
3
2
1
4
5
Index
Chapter 2 Installation and Wiring
2.1 Handling Precautions
This section describes the precautions to be taken when using the MX100. Please read
this section carefully before use.
• If you are using this instrument for the first time, make sure to thoroughly read the
safety precautions given on pages ii and iii.
• Do not remove the case.
For internal inspection or adjustment, contact your nearest YOKOGAWA dealer.
• Do not place objects on top of the instrument.
Never place other instruments or objects containing water on top of the instrument.
Doing so can lead to malfunction.
• Take Proper Care When Carrying the Instrument
First, turn off the DUT and the MX100 and remove all cables including measurement
wires and communication cables. Then, remove the power cord from the outlet.
• To prevent internal overheating, do not obstruct the vent holes of the module.
• This instrument uses many plastic parts. When cleaning, wipe using a dry soft cloth.
Do not clean with benzine, thinner, or other chemicals, and do not use detergents.
Doing so can cause discoloring, deformation, or damage.
• Do not bring charged objects near the signal terminals. Doing so can lead to
malfunction.
• Do not pour volatile agents on the MX100 or leave it in contact with rubber or PVC
products for an extended time. Doing so can lead to malfunction.
• Do not apply shock to the instrument.
• When not in use, make sure to turn OFF the power.
• If there are any symptoms of trouble such as smoke, strange odors, or strange sounds
coming from the instrument, immediately turn OFF the power and stop the power
supply. Contact your dealer immediately.
• Do not damage the power cord.
Nothing should be placed on top of the power cord. The power cord should also be
kept away from any heat sources. When unplugging the power cord from the outlet,
never pull by the cord itself. Always hold and pull by the plug. If the cord is damaged,
contact your dealer for replacement. Refer to “Checking the Contents of the Package”
in the MX100 Data Acquisition Unit Operation Guide (IM MX100-02E) for the part
number of the appropriate power cord when placing an order.