Thermo Fisher Scientific CyberScan CON 1500 - Manual (Page 4)

TABLE OF CONTENTS
1. INTRODUCTION 1
2. GETTING STARTED 2
2.1. Connectors 2
3. USING THE METER 4
3.1. Conductivity Probes 4
3.2. Display/ Keys 6
3.3. Screen Display 7
4. CONDUCTIVITY OPERATION 8
4.1. Using Setup 8
4.2. Overview of Setup Pages in CyberScan CON 1500 9
4.2.1 Setup Page 1.0: View the Cal data 10
4.2.2 Setup Page 2.0: Set cell constant 13
4.2.3 Setup Page 3.0: Set Temperature Coefficient 15
4.2.4 Setup Page 4.0: Set the Normalisation Temperature 17
4.2.5 Setup Page 5.0: Set the Auto Calibration mode (ACAL for Conductivity mode only) 19
4.2.6 Setup Page 5.0: Set the Calibration mode (SPCAL for all modes) 21
4.2.7 Setup Page 6.0: Set the TDS Factor. (Only applicable in TDS mode) 23
4.2.8 Setup Page 7.0: Set the Temperature Unit. 25
4.2.9 Setup Page 8.0: Set the Stability Indicator 27
4.2.10 Setup Page 9.0: Set the Baud Rate 29
4.2.11 Setup Page 10.0: Set the Parity Bit 31
4.2.12 Setup Page 11.0: Set the Stop Bit 33
4.2.13 Setup Page 12.0: Select the Print option 35
4.2.14 Setup Page 13.0: Clear Stored Data 37
4.2.15 Setup Page 14.0: Clear User calibration 39
4.2.16 Setup Page 15.0: Replatinisation Process 41
5. STANDARDISATION 44
5.1. Conductivity standardisation (Manual) 45
5.2. Conductivity standardisation (Auto) 47
5.3. Resistivity Standardisation (Manual) 49
5.4. TDS Standardisation (Manual) 51
6. TEMPERATURE CALIBRATION 53
7. MEASUREMENT 55
7.1. Conductivity Measurement 55
7.2. Resistivity Measurement 56
7.3. TDS Measurement 57
8. MEMORY 58
8.1. Store Value into Memory 58
8.2. Recall Value from Memory 58
9. PRINT DATA 59
9.1. Printing Data 59
10. CONDUCTIVITY THEORY 60
11. CLEANING 64
12. TROUBLESHOOTING 64
13. WARRANTY 65
14. NOTICE OF COMPLIANCE 66
15. METER SPECIFICATIONS 67
18 ACCESSORIES 68