Thermo Fisher Scientific CyberScan CON 1500 - Manual (Page 8)

Instruction Manual CyberScan CON 1500
4
3. USING THE METER
3.1. Conductivity Probes
This meter allows you to use either the 2-cell or 4-cell conductivity
probes.
)
DO NOT connect both probes together.
Remove the protective cover from the end of the probe. Prior to use,
soak the probe in distilled or deionised water for 10 minutes. You
may either:-
1. Connect the 2-cell probe by plugging its
pin connectors into the dual pin sockets
located at the rear panel of the meter.
2. Connect the 4-cell probe by plugging its
DIN connector into the DIN socket at the
rear panel of the meter.
3. Connect the ATC probe by plugging the
1/8” mini-phone jack into the ATC socket
located at the rear panel of the meter.
)
The Eutech Instruments 4-cell probe has a built-in temperature
sensor and therefore a separate ATC probe is not required.