Badger Meter M-Series M2000 - Manual (Page 29)

USING THE M2000 MAIN MENU PROGRAMMING OPTIONS
The following M2000 programming options are available from the Main Menu:
•
Meter Setup
• Measurements
• Inputs/Outputs
• Clear Totals
• Communications
• Advanced
• Info/Help
• Language Select
In the section that follows, the applicable security level for each menu option is indicated as follows:
A S U
Administrative Service User
Options that can be set at Quick Setup are indicated with:

The factory default values are shown, enclosed in brackets
NOTE: N Options that are listed [Factory Set] should not be changed without specific directions from authorized Badger Meter
personnel
Meter Setup
Scale Factor
[0 0%]
S
Changing the scale factor lets you adjust the meter's accuracy without disturbing factory-set
parameters You can tune the meter to meet changing application requirements For example, if the
meter is under registering by 0 5 percent then set the scale factor to +0 5% If the meter is over
registering by 0 5 percent then set the scale factor to –0 5%
To set the Scale Factor, follow these steps from the Meter Setup menu:
1 Select Scale Factor, to open the Detector Factor display
2 Set the Detector Factor value to the desired setting
3 Press [E], to save the new value and return to the Meter Setup menu
Empty Pipe Detect
[Off]
S
When set to On, Empty Pipe Detect indicates to the outputs and the display that the meter is not
completely filled When set to Off, empty pipe detect is disabled
Enabling empty pipe detect requires a one-time calibration Calibration is described in the Advanced
menu section under Empty Pipe Cal
To set Empty Pipe Detect, follow these steps from the Meter Setup menu:
1 Select Empty Pipe Detect to view the Empty Pipe Detect display
2 Position the arrow next to On or Off
3 Press [E] to save the Empty Pipe Detect On or Off and return to the Meter Setup menu
Installation & Operation Manual
Page 29 August 2012