Badger Meter M-Series M2000 - Manual (Page 53)

The following table demonstrates how the totalizers are displayed under various configurations of the Unit Multiplier (that is,
resolution) and Dial Type The non-shaded digits are transmitted as defined by the dial type
For example, if the dial type is 4-dial and the resolution is 10000 then an arbitrary totalizer value of 99999999 is displayed on
the meter as 99990000 and 9999 is transmitted to the receiving application In this configuration it will take 10000 units (i e
USG) before the display totalizer is updated to a new value For this example the display totalizer will rollover to 00000000
Dial
Type
Unit Multiplier
(Resolution)
Display Digits
1 2 3 4 5 6 7 8 9 0
4 dial
10000 1 2 3 4 0 0 0 0
1000 1 2 3 4 0 0 0
100 1 2 3 4 0 0
10 1 2 3 4 0
1 1 2 3 4
0 1 1 2 3 4
0 01 1 2 3 4
0 001 1 2 3 4
0 0001 0 0 1 2 3 4
5 dial
10000 1 2 3 4 5 0 0 0 0
1000 1 2 3 4 5 0 0 0
100 1 2 3 4 5 0 0
10 1 2 3 4 5 0
1 1 2 3 4 5
0 1 1 2 3 4 5
0 01 1 2 3 4 5
0 001 1 2 3 4 5
0 0001 1 2 3 4 5
6 dial
10000 1 2 3 4 5 6 0 0 0 0
1000 1 2 3 4 5 6 0 0 0
100 1 2 3 4 5 6 0 0
10 1 2 3 4 5 6 0
1 1 2 3 4 5 6
0 1 1 2 3 4 5 6
0 01 1 2 3 4 5 6
0 001 1 2 3 4 5 6
0 0001 1 2 3 4 5 6
7 dial
10000 Not Applicable – Not enough display digits
1000 1 2 3 4 5 6 7 0 0 0
100 1 2 3 4 5 6 7 0 0
10 1 2 3 4 5 6 7 0
1 1 2 3 4 5 6 7
0 1 1 2 3 4 5 6 7
0 01 1 2 3 4 5 6 7
0 001 1 2 3 4 5 6 7
0 0001 1 2 3 4 5 6 7
Installation & Operation Manual
Page 53 August 2012