Badger Meter M-Series M2000 - Manual (Page 37)

Inputs/Outputs
Digital Output Output Type
[1: Normally Open]
[2: Normally Open]
[3: Normally Open]
[4: Normally Closed]
S
The Output Type parameter lets you set the output switch to normally open
or normally closed If normally open is selected, the output switch is open (no
current) when the output is inactive, and closed (current flows) when the output
is active
If normally closed is selected, the output switch is closed (current flows) when
the output is inactive, and open (no current) when the output is active
To change the Output Type, follow these steps from the Inputs/Outputs main
menu:
1 Select Digital Output 1, 2, 3 or 4 and press [E] to open the Digital Output
menu
2 From the Digital Output menu, select Output Type and press [E] to open
the Output Type display
3 Select Normally Open or Normally Closed
4 Press [E] to save the new parameter and return to the Digital Output
menu
Hardware Type
[3: Open Collector]
[4: Open Collector]
S
The Hardware Type parameter lets you select the type of hardware used to drive
the output signal: either open collector or solid-state relay
To change the Hardware Type, follow these steps from the Inputs/Outputs main
menu:
1 Select Digital Output 3 or 4 and press [E] to open the Digital Output
menu
2 From the Digital Output menu select Hardware Type, and press [E] to
open the Hardware Type display
3 Select Open Collector or Relay
4 Press [E] to save the new parameter and return to the Digital Output
menu
Full Scale Frequency
[3: 1000 Hz]
S
The Full Scale Frequency parameter establishes the full scale flow output
frequency when the flow rate equals the configured full scale flow
To change the Full Scale Frequency, follow these steps from the Inputs/Outputs
main menu:
1 Select Digital Output 3 and press [E] to open the Digital Output menu
2 From the Digital Output menu select Full Scale Frequency, and press [E]
to open the Full Scale Frequency display
3 Set the full scale frequency value to the desired setting
4 Press [E] to save the new parameter and return to the Digital Output
menu
Installation & Operation Manual
Page 37 August 2012