Badger Meter M-Series M2000 - Manual (Page 43)

Advanced Features
Unit Multiplier
[Off]
U
The Unit Multiplier establishes the number of units of measure that have to accumulate before the
display totalizers are updated This is also known as setting the number of “dead” zeroes in the display
totalizer For example:
Unit Multiplier less than 1
Unit Multiplier Example
OFF
0.00000 USG 0.00012 USG 0.00123 USG 0.01234 USG 0.12345 USG
0.0001 0.0000 USG 0.0001 USG 0.0012 USG 0.0123 USG 0.1234 USG
0.001 0.000 USG 0.000 USG 0.001 USG 0.012 USG 0.123 USG
0.01 0.00 USG 0.00 USG 0.00 USG 0.01 USG 0.12 USG
0.1 0.0 USG 0.0 USG 0.0 USG 0.0 USG 0.1 USG
Unit Multiplier greater than or equal to 1
Unit Multiplier Example
OFF
0.00000 USG 1.23456 USG 12.34567 USG 123.4567 USG 1234.456 USG
1 0 USG 1 USG 12 USG 123 USG 1234 USG
10 0 USG 0 USG 10 USG 120 USG 1230 USG
100 0 USG 0 USG 0 USG 100 USG 1200 USG
1000 0 USG 0 USG 0 USG 0 USG 1000 USG
To change the Unit Multiplier, follow these steps from the Advanced menu:
1 Select Unit Multiplier to view the Unit Multiplier display
2 Select the desired unit multiplier
3 Press [E] to save the option and to return to the Advanced menu
Backlight Control
[Timed Off]
U
You can set the meter's backlight to: Always On, Always Off and Timed Off
When set to Timed Off, the backlight will automatically turn off after one minute of inactivity
(no buttons pressed) Pressing any button will turn the backlight on, but will not immediately
navigate the menu
To change the backlight control, follow these steps from the Advanced menu:
1 Select Backlight Control to view the Backlight Control display
2 Select the desired option
3 Press [E] to save the option and to return to the Advanced menu
Token Copy Configuration
Refer to IOM-194-XX-EN for details on using the
Token Copy features
Store to Token
Restore from Token
Installation & Operation Manual
Page 43 August 2012