HP Color LaserJet 8550 Multifunction Printer series - Manual (Page 182)

182 Chapter 5 Image manipulation
EN
4 Select
YES
or
NO
when the
PERFORM
FRAMING/BLANKING?
message
appears, and then press
OK
.
If you select
NO
, press
OK
and
proceed to step 5.
Selecting
YES
allows you to specify
what part of the original to use for the
mirror image. If you select
YES
, refer
to the Framing instructions on
page 165 or the Blanking instructions
on page 170. Press
OK
.
Note
If
FRAMING
is selected, the copy module
will proceed to make mirror-image
copies of only the designated area on
the original. If
BLANKING
is selected, the
copy module will proceed to make
mirror-image copies excluding the
designated area on the original.
5 Press
DONE
on the screen pictured
here, and on the subsequent screen
(not pictured). Then press
S TART to
make copies.
Note
The setting confirmation button (not
pictured) will appear in the upper
right-hand corner of the touch panel
display to show that special features
have been selected. Press this button to
display any set special features.
4
5