HP NetRAID-4M Controller - Manual (Page 188)

8-16
Command Line Interface User’s Guide
Num Total Oth Stripe Scsi Partition
Dr Label Type Size Ctr Size Usage C:ID:L Offset:Size
-- ----- ------ ------ --- ------ ------- ------ -------------
0 RAID-5 100MB NTFS 2:01:0 64.0KB: 50.0MB
2:02:0 64.0KB: 50.0MB
2:03:0 64.0KB: 50.0MB
1 RAID-5 100MB NTFS 2:01:0 50.0KB: 50.0MB
2:02:0 50.0KB: 50.0MB
2:03:0 50.0KB: 50.0MB
To create a stripe set of RAID-5 sets, use the container create
mstripe command, as in the following example. In the example,
containers 0 and 1 are used to create a stripe set of RAID-5 sets. The
stripe size is not specified; therefore, the stripe size is 32KB, which is
the default size.
HPN0> container create mstripe 0 1
Executing: container create mstripe 0 1
Container 0 created
After running the container create mstripe command, use
the container list command to display information about the
stripe set of RAID-5 sets, as in the following example. In the
example, the Type column indicates a top-level Stripe set, whose
container ID is 0, and two underlying RAID-5 sets, whose container
IDs are 63 and 62. (Container’s 62 and 63 are hidden containers.)
These three containers make up the stripe set of RAID-5 sets. The
Total Size
column indicates that the stripe set of RAID-5 sets is
200MB (megabytes), which is the total size of the two underlying
RAID-5 sets. The Stripe Size column indicates that the size of each
stripe is 32KB (kilobytes).
HPN0> container list
Executing: container list
Num Total Oth Stripe Scsi Partition
Dr Label Type Size Ctr Size Usage C:ID:L Offset:Size
-- ----- ------ ------ --- ------ ------- ------ -------------
0 Stripe 200MB 32KB None
63 RAID-5 100MB 2:01:0 64.0KB: 50.0MB
2:02:0 64.0KB: 50.0MB