HP NetRAID-4M Controller - Manual (Page 98)

5-20
Command Line Interface User’s Guide
After running the disk_set detach command to detach a
diskset, use the disk_set list command to display information
about your disksets, as in the following example. In the example, the
Attached
column indicates NO, which means that the diskset is
detached. Note that the example alters the disk_set list output
so that the data can fit on the page.
HPN0> disk_set list
Executing: disk_set list
Diskset ID Creator ID Owner
------------------- ------------------ ------------------
0x01be868c1d74a640 0xfafaf001007a1c00 \\.\HPN0
Disks Attached OS Managed Label Shared Spare
------ -------- ---------- ---------- ------ -----
3 NO NO Saturn YES NO
Changing a Diskset’s Label
You use the disk_set changelabel command to change a
diskset’s label. To change a diskset’s label, the diskset must be
owned by either the controlling or peer partner.
Before changing a diskset’s label, use the disk_set list
command to display information about your disksets, as in the
following example. In the example, the Label column indicates that
Saturn
is the diskset’s label. Note that the example alters the
disk_set list output so that the data can fit on the page.
HPN0> disk_set list
Executing: disk_set list
Diskset ID Creator ID Owner
------------------- ------------------ ------------------
0x01be868c1d74a640 0xfafaf001007a1c00 \\.\HPN0
Disks Attached OS Managed Label Shared Spare
------ -------- ---------- ---------- ------ -----
3 YES NO Saturn YES NO