HP NetRAID-4M Controller - Manual (Page 252)

9-44
Command Line Interface User’s Guide
Container 0 extended.
After running the container extend mvolume command, use
the container list command to display information about the
container, as in the following example. In the example, the Type
column indicates that container 0 is a multi-level container of
volume
sets made up of underlying containers 63, 62, 61, and 60.
HPN0> container list
Executing: container list
Cluster Num Total Oth Stripe Scsi Partition
Dr Partner Label Type Size Ctr Size Usage C:ID:L Offset:Size
-- ------- ----- ------ ------ --- ------ ------- ------ -------------
F: 0 0 Volume 500MB NTFS
0 63 Volume 100MB 2:01:0 64.0KB: 100MB
0 62 Volume 200MB 2:02:0 64.0KB: 200MB
0 61 Volume 100MB 2:03:0 64.0KB: 100MB
0 60 Volume 100MB 2:04:0 64.0KB: 100MB
Taking a Container Offline
The CLI allows you to take a container offline. You use the
container offline command to take a container offline.
To take a container offline, you must understand:
■ The container offline attributes you can specify
■ How to take a container offline
The following sections discuss each of these topics.
Understanding the Container Offline Attributes You Can
Specify
You use the container offline command to take a container
offline. The container offline command has no attributes.
Understanding How to Take a Container Offline
This section provides an example that describes how to take a
container offline.
Before taking a container offline, use the container list
command to display information about your containers, as in the
following example. In the example, the Num Label column