HP NetRAID-4M Controller - Manual (Page 201)

8-29
Working with Multi-level Containers
Understanding the Volume Set of Volume Sets Attribute You can
Specify
You use the container create mvolume command to create a
volume set of volume sets. Before creating a volume set of volume
sets, consider the following volume set of volume sets attribute you
can specify:
■ container label
Specifying a Label for a Volume Set of Volume Sets
The container label attribute indicates a name assigned to a
container. Note that this label is not the label that displays in
Windows Explorer and Disk Administrator. You can specify a label
while creating a volume set of volume sets or at a later time using
the
container set label command to specify a label at a later
time. See Displaying and Setting a Container Label in Chapter 6,
Working with Container Attributes, for a description of the
container set label command.
In the following example, the container create mvolume
command with the /label switch creates a volume set of volume sets
with the label Earth.
HPN0> container create mvolume /label=Earth 0 1
Executing: container create mvolume /label="Earth" 0 1
Container 0 created
Understanding How to Create a Volume Set of Volume Sets
This section provides an example that describes how to create a
volume set of volume sets.
Before creating a volume set of volume sets, be sure that the volume
sets that are to makeup the volume set of volume sets have been
created. See Working with a Volume Set in Chapter 7, Working With
Single-level Containers, for information on creating a volume set. Use
the
container list command to display information about your
containers, as in the following example. In the example, the Type
column indicates that two Volume sets reside on containers 0 and 1.
HPN0> container list
Executing: container list
Cluster Num Total Oth Stripe Scsi Partition
Dr Partner Label Type Size Ctr Size Usage C:ID:L Offset:Size