HP NetRAID-4M Controller - Manual (Page 276)

11-8
Command Line Interface User’s Guide
HPN0> diagnostic moderation set count 100
Executing: diagnostic moderation set Count 100
After running the diagnostic moderation show count
command to set the interrupt count, use the diagnostic
moderation show count command to display the interrupt
count, as in the following example. In the example, the The
moderation count is currently set to
line indicates that the interrupt
count is set to 100 I/O requests.
HPN0> diagnostic moderation show count
Executing: diagnostic show Count
The moderation count is currently set to 100.
Setting the Interrupt Timer
You use the diagnostic moderation set timer command to
set the default interrupt time on a controller. The interrupt time is
the time delay in 100 microsecond units before a controller issues an
interrupt to the host computer.
Before setting the interrupt time, use the diagnostic
moderation show timer command to display the current
interrupt time, as in the following example. In the example, the The
moderation timer is currently set to
line indicates that the interrupt
time is set to 10 milliseconds (that is, 10 milliseconds = 100 x 100
microseconds).
HPN0> diagnostic moderation show timer
Executing: diagnostic moderation show Timer
The moderation timer is currently set to 100.
To set the interrupt time, use the diagnostic moderation set
timer command, as in the following example. In the example, the
diagnostic moderation set timer command sets the interrupt time to
20 milliseconds (that is, 20 milliseconds = 200 x 100 microseconds).
HPN0> diagnostic moderation set timer 200
Executing: diagnostic moderation set Timer 200
After running the diagnostic moderation set timer
command to set the interrupt time, use the diagnostic
moderation show timer command to display the current
interrupt time, as in the following example. In the example, the The
moderation timer is currently set to
line indicates that the interrupt