Buhler 535 - Manual (Page 112)

435/485/535
3-83
ON
N
N N
N
N N
F3-108
F3-105
F3-119
Electro-Hydraulic Remote Control Valves
Remote control valves are available to operate external
hydraulic cylinders, motors, etc . The valves are located
at the rear of the tractor .
Tractors with a standard hydraulic system can be
equipped with four or six remote control valves .
Tractors with a high flow hydraulic system can be
equipped with six or eight remote control valves .
NOTE: The total system flow is not available to operate
any one single hydraulic circuit. The maximum
available flow from any one remote valve is 95 ± 8
L/min (25 GPM± 2 GPM).
Electro-Hydraulic (EHR) Control Pods
The EHR valves are operated by finger controlled levers
located in the Control Pods () (two valves per pod) .
Each control lever is identified by a color coded decal
(6) which corresponds with it’s color coded remote
valve .
The remote valve control levers have four positions:
neutral, extend, retract and float .
Pull the lever back from the neutral position (2) to
the “extend” (raise) position (3) . From neutral, push
forward to the “retract” (lower) position (4) . Push the
lever fully forward to the float position (5) .
1
2
4
5
3
6
Section 3 - Operation
Hydraulic Operation - Electro-hydraulic