Buhler 535 - Manual (Page 197)

5-
435/485/535
Correction
Review starting procedures.
Check fuel level.
Bleed fuel system.
Use correct viscosity oil.
Use correct type fuel for
temperature conditions.
Clean system/replace filter element.
Replace filter element.
Contact Buhler Versatile dealer.
Contact Buhler Versatile dealer.
Clean or replace air filter.
Replace filter.
Clean or replace air filter.
Refer to “Cold-Weather Starting”
(Section 3).
Clean system replace filter element.
Contact Buhler Versatile dealer.
Shift to lower gear or reduce load.
Service air cleaner.
Replace filter.
Use correct fuel.
See “Engine Overheats” (later
in this chart).
Contact Buhler Versatile dealer.
See implement operator’s manual.
Contact Buhler Versatile dealer.
Contact Buhler Versatile dealer.
Refer to EICS operation (Section 3).
Contact Buhler Versatile dealer.
Disengage cruise control or reset to
higher speed.
Possible Cause
Incorrect starting procedure.
Low or no fuel.
Air in fuel lines.
Incorrect engine oil viscosity.
Incorrect fuel for operating
temperature.
Contaminated fuel system.
Clogged fuel filter.
Malfunctioning fuel injector(s).
Malfunctioning fuel solenoid.
Clogged air filter.
Clogged fuel filter.
Clogged air filter.
Engine cylinder temperature too
low for clean fuel burn.
Contaminated fuel system.
Malfunctioning fuel injector(s).
Engine overloaded.
Air cleaner restricted.
Clogged fuel filter.
Incorrect type of fuel.
Engine overheated.
Low engine operating temperature.
Implement incorrectly adjusted.
Malfunctioning fuel injector(s).
High idle speed is low.
Engine Power Derate
Cruise control set too low
Section 5 - Troubleshooting
Engine
Engine
Problem
Engine will turn over but
will not start, or starts
hard
Engine runs rough and/
or stalls
Engine does not appear
to develop full power