Buhler 535 - Manual (Page 150)

435/485/535
4-7
Operation 15
Lubricate the Front Drag Link Pins
Lubricate the grease fittings (one on each side) ()
until grease flows from around the pin seals . This will
purge any dirt accumulated in the pivot pin area .
Use Moly base grease (NLGI  Lithium, Moly) .
Operation 16
Lubricate the Rear Drag Link Pins
Lubricate the top two grease fittings (2) remotely
mounted on the left rear frame, until grease flows
from around the pin seals . This will purge any dirt
accumulated in the pivot pin area .
Use Moly base grease (NLGI  Lithium, Moly) .
Operation 17
Lubricate the Rear Axle Drive Shaft Steady Bearing
Lubricate the grease fitting (3) until grease flows from
the bearing area . This will purge any dirt accumulated
in this area .
Use Moly base grease (NLGI  Lithium, Moly) .
F4-22
1
F4-21
2
F4-23
3
Section 4 - Lubrication & Maintenance
Every 10 Hours or Daily