Buhler 535 - Manual (Page 71)

3-42
435/485/535
Section 3 - Operation
EIC - Calibration
2. Slip percent threshold
On tractors equipped with an optional radar speed
sensor, the slip alarm can be used to notify the
operator whenever the wheel slip percentage is above
a certain threshold .
 . To set the slip alarm threshold, enter the desired
maximum percent slip () . The selected (flashing)
digit can be changed by touching the UP and
DOWN arrow buttons (2) . Other digits may be
selected by touching the LEFT and RIGHT arrow
buttons (3) . The alarm can be disabled entirely by
setting the threshold value to zero .
2 . Once the desired threshold value has been entered,
touch SELECT button (4) to confirm the change .
3. Setting the service alert intervals
The two service alert intervals can be used to remind
the operator that regular scheduled maintenance
is required . The service alerts are based on engine
hours . If, for example, a service alert is set to 50
hour intervals, it will become active at 50 hours,
00 hours, 50 hours, etc . Once a service interval
becomes active, the word “SERVICE” (5) will flash in
the lower portion of the central display until the alert
is cleared by the operator .
 . To set a service alert interval, enter the desired
number of hours . The selected (flashing) digit can
be changed by touching the UP and DOWN arrow
buttons (2) . Other digits may be selected by touching
the LEFT and RIGHT arrow buttons (3) .
2 . Once the interval has been entered, touch the
SELECT button (4) to confirm the change .
3 . If a service interval is active, the service alert
display will be flashing . Hold the START/STOP
button (6) to clear the alert .
F3-125
MPH
km/h
540
PTO
1000 SERVICE
5
F3-140
2
3
1
4
6