Buhler 535 - Manual (Page 85)

3-56
435/485/535
Stopping the Tractor
 . Gradually slow down the tractor . Set the throttle as
low as possible .
2 . Disengage the clutch, apply the brake and put the
controls into neutral .
3 . Reduce the engine speed to Idle . Run the engine
for 3 to 5 minutes before shutdown to allow the
engine to cool .
4 . Shut down the engine and remove the key .
Turn all electrical accessories OFF .
5 . Ensure that the parking brake is engaged before
exiting the tractor .
IMPORTANT: If the engine has overheated, allow it
to idle an extended length of time to reduce the
temperature. If the temperature does not return to
normal or the coolant level warning lamp is ON,
shut down the tractor immediately.
CAUTION: KEEP THE CAB FLOOR AREA FREE FROM
DEBRIS OR OBJECTS WHICH MAY OBSTRUCT THE
OPERATION OF THE BRAKE PEDAL. KEEP THE
PEDAL CLEAN AND DRY TO PREVENT YOUR FOOT
FROM SLIPPING OFF THE PEDAL.
DANGER: NEVER LEAVE THE OPERATOR’S SEAT
WITHOUT FIRST BRINGING THE TRACTOR TO A
COMPLETE STOP USING THE FOOT BRAKE, AND
THEN ENGAGING THE PARKING BRAKE.
DANGER: NEVER OPERATE THE TRACTOR IF THE
FOOT OR PARKING BRAKE DOES NOT FUNCTION
PROPERLY.
DANGER: NEVER RELY SOLELY ON THE
TRANSMISSION TO HOLD THE TRACTOR
STATIONARY WHEN PARKED, ALWAYS ENGAGE
THE PARKING BRAKE.
Section 3 - Operation
Tractor Operation
Using the deceleration pedal (4) in cruise mode
works the same as moving the throttle handle . If the
decelerator pedal causes the engine speed to decrease
past the cruise setting, the cruise speed will decrease
as well . When the decelerator pedal is released, the
cruise RPM will return to the specified setting .
It is not
possible to use the “+” button to increase the cruise
setting higher than the current throttle position.
Exiting Cruise Mode - Pressing the “OFF” button (2)
exits cruise mode and returns to the normal engine
speed for the current throttle position . The cruise
function can be used in this way for two-speed
applications . The throttle position for high speed, the
cruise setting for low speed .