Buhler 535 - Manual (Page 72)

435/485/535
3-43
F3-61
SPEED
PTO RPM AREA
START
STOP
% SLIP
DISTANCE
SELECT
1
6
F3-121
SPEED
PTO RPM AREA
START
STOP
GAL CAL
FT
% SLIP
DISTANCE
SELECT
4
1
2
4
F3-124
SPEED
PTO RPM AREA
START
STOP
CAL
% SLIP
DISTANCE
SELECT
AREA
1
2
3
4
5
Section 3 - Operation
EIC - Calibration
4. Setting the area preset
The area accumulator calculates the total area covered
by the tractor . The accumulated area is stored in the
area preset when the tractor is switched off . When the
tractor is started again, area accumulation starts from
the stored preset .
 . To modify the area preset, enter the desired area .
The selected (flashing) digit (3) can be changed by
touching the UP and DOWN arrow buttons (4) . Other
digits may be selected by touching the LEFT and
RIGHT arrow buttons (5) .
2 . The area preset may be cleared by holding the
START/STOP button (2) for two seconds .
3 . Once the desired area preset has been entered,
touch the SELECT button () to confirm the change .
5. Turning active fault display on/off
Whenever a fault is detected by the electrical system,
a fault code is stored in the EIC memory, and the
flashing book icon appears in the TPM display . If
active fault display is turned on the fault code will also
be displayed as a flashing number in the TPM .
 . To toggle active fault display, touch the UP and
DOWN arrow button (4) . When active fault display
is on, the display will show “ON” (6) and fault
code . When active fault display is off, the display
will only show “OFF” .
2 . Touch the SELECT button () to confirm the
change .
6. Selecting between Imperial and Metric units
The EIC can display measurements in either English
(Imperial) units, or in Metric units .
 . To select the desired display units, touch the UP
and DOWN arrow buttons (4) . When English units are
selected, the display will show “˚F”, “GAL”, and
“FT” . When Metric units are selected, the display
will show “˚C”, “L”, and “METERS” .
2 . Touch the SELECT button () to confirm the
change .
To exit Mode 1
Touch the START/STOP button (2) to return to
the calibration menu . Touch the START/STOP
button (2) again to return to normal operation .