Buhler 535 - Manual (Page 132)

435/485/535
3-03
Section 3 - Operation
Ballasting
Weight bracket removed for clarity
Remove the block and remove the remaining four
weights from the bracket together with the tie rod .
NOTE: When installing fewer weights make sure that
they are positioned in the center of the bracket.
NOTE: For details on the upper weight kit bracket see
page 4-25.
Rear weights
The rear weight kit is available with a set of twelve,
twenty four or forty two, 30 kg (67 lbs), suitcase style
weights (2) . The bracket (3) and hardware, weighs
approximately 98 kg . (25 lbs) .
NOTE: The rear weight kit cannot be installed on units
that have a PTO option or a 3-point hitch option. The
PTO or 3-point hitch is considered part of the rear axle
ballast.
Rear weights can be removed by releasing the left
hand tie rod nuts (4) and withdrawing the tie rod
fully toward the opposite fender . Loosen the bolt (5)
on the rear of the bracket releasing the cast block
(0) .
NOTE: The last four weights on the right and left
hand side are held in place by the cast block installed
through the weight cut out. The remaining weights are
held in position by the tie rod.
Pry upward on the fifth weight (6) from the left and
remove it from the tractor . Starting with the sixth
weight from the left remove six additional weights
from the bracket . Slide the four remaining left hand
weights to the right and remove . Remove the cast
block (0) . Slide the remaining weights to the left and
remove them from the bracket . This will expose the
right hand retaining block .
Remove the block and remove the remaining four
weights from the bracket together with the tie rod .
NOTE: When installing fewer weights make sure that
they are positioned in the center of the bracket.
NOTE: For details on the upper weight kit bracket see
page 4-25.
F3-133
F3-134
10
13
F3-135
15
14 16 12