Buhler 535 - Manual (Page 38)

435/485/535
3-9
F3-7
Deluxe Seat
The seat is equipped with controls to permit the
following adjustments for personal comfort .
NOTE: All adjustments should be made in the following
order while sitting in the seat.
Adjust the seat using the following procedures:
NOTE: With the engine off, adjust the seat by
turning the ignition switch the “ACC” position.
DO NOT START THE ENGINE.
1. Height/Weight Adjustment
Depress the top of the switch to raise the seat . Release
when the desired height is obtained .
Depress the bottom of the switch to lower the seat .
Release when the desired height is achieved .
2. Backrest Angle Adjustment
Lift the lever and tilt the backrest to the desired
position . Release the lever to lock the backrest in
position .
NOTE: The backrest will tilt backward far enough to
contact the rear window.
3. Fore/Aft Float
Pull up on the lever to allow the seat to float fore and
aft 5 mm (2”) . Push down on the lever to lock the
seat into position .
4. Lateral Float
Pull up on the lever to allow the seat to float laterally
5 mm (2”) . Push down on the lever to lock the seat
into position .
5. Swivel Adjustment
Pull up on the lever to swivel the seat . Push down on
the lever to lock the seat into position .
6. Fore/Aft Position Adjustment
Pull up on the lever to move the seat forward
or backward to the desired position . Push down
on the lever to lock the seat into position .
1
2
3
4
5
6
Section 3 - Operation
Cab Features - Seating
7
7. Storage tray
Pull out for access .