Buhler 535 - Manual (Page 138)

435/485/535
4-5
F4-3
F4-2
Inspection Access
Engine Access
In order to perform service, inspection and lubrication
operations to the tractor, it may be necessary to open
or remove various panels and shields .
IMPORTANT: After performing work on the tractor,
install all safety shields before operating the tractor.
Battery Access
The batteries are located on top of the right side fuel
tank . Release the latch () and lift the battery cover .
Make sure the cover is down and latched when
operating the tractor .
Opening the Hood Panels
To provide easy access to the engine, each hood side
panel swings open vertically . There is an external latch,
(2) that releases the panel . Each panel is held open
by a single gas strut . Close the hood panels by pulling
downward from the side of it and keeping a steady
pressure on the panel . The gas strut will collapse and
the panel will go over center and latch . Do not force
the panel down against the gas strut .
Removing the Hood Panels
The hood panels can be easily removed if greater access
is required for maintenance or service operations .
 . Remove the hairpin clips (3) from the front and rear
pivot studs retaining the hood panel hinge plates .
2 . Disconnect the gas strut from the hood panel .
3 . Slide the panel forward to clear the pivot studs and
lift clear .
4 . Set the panel clear of the working area to prevent
damage .
To reinstall the panels, reverse the above procedure .
Section 4 - Lubrication & Maintenance
Inspection Access
2
3
F2-13
1