Buhler 535 - Manual (Page 67)

3-38
435/485/535
F3-51
SPEED
PTO RPM AREA
START
STOP
VOLTS
% SLIP
DISTANCE
SELECT
F3-50
SPEED
PTO RPM AREA
START
STOP
ALARM
%SLIP
% SLIP
DISTANCE
SELECT
Metric display (hectares), designated by METERS
legend starts to accumulate in increments of .0
hectares . When 00 .0 hectares are reached, area
accumulation continues in increments of 0 .
hectares until 000 is reached . The display will then
accumulate whole hectares . When 9999 hectares are
reached, the display will reset to zero .
With AREA selected, area accumulation can be reset
to zero by holding down the START/STOP button for
three seconds until a “beep” is heard from the audible
alarm .
NOTE: If the radar option is not installed, area
calculations are based on axle speed and are subject
to inaccuracies caused by wheel slip that may be
present.
Wheel Slip (with Radar Option)
Touch the % SLIP selector button () . The “% SLIP”
legend (2) will display together with a two-digit slip
value (3) in the main TPM display . The slip value
is detected by the comparison of theoretical ground
speed (axle rotation sensor) with true ground speed
(radar sensor) .
WARNING: THE RADAR GROUND SPEED SENSOR
EMITS A LOW INTENSITY MICROWAVE SIGNAL
WHICH WILL NOT CAUSE ANY ILL EFFECTS IN
NORMAL USE. ALTHOUGH THE SIGNAL INTENSITY
IS LOW, DO NOT LOOK DIRECTLY INTO THE FACE
OF THE SENSOR WHILE IN OPERATION SO AS TO
AVOID EYE DAMAGE.
Slip Alarm (with Radar Option)
A slip alarm point may be entered - see “EIC
Programming .” When wheel slip exceeds the value
entered, the alarm will sound for one second . If wheel
slip is selected, the “% SLIP” (2) legend will be
displayed . In addition, the “ALARM” (4) legend will
flash and continue to flash until wheel slip is reduced
below the preset level .
Battery Voltage
Touch the SELECT button (5) until the “VOLTS”
legend (6) is displayed together with a digital display
of battery voltage (7) to the nearest tenth volt .
3
1 4 2
6 5 7
Section 3 - Operation
EIC - Tractor Performance Monitor (TPM)