Buhler 535 - Manual (Page 57)

3-28
435/485/535
F3-34
F3-33
In the event of an engine fault occurring,  of 3
warning lamps will flash depending on the level of the
fault .
4. Engine Maintenance - Attention (white lamp)
Illuminates when engine maintenance is required .
A fault code is also displayed .
5. Engine Maintenance - Warning (yellow lamp)
Illuminates when a non-critical fault occurs in the
electronic engine control system . As soon as possible,
contact your Buhler Versatile dealer .
6. Engine Maintenance - Critical (red lamp)
Illuminates when a critical fault occurs in the electronic
engine control system . The alarm will sound and
the engine “STOP” message will flash in the center
display for 30 seconds before automatic engine shut
down occurs . The cause of the malfunction should be
located and corrected immediately to prevent damage
to the tractor .
7. Air Filter Restriction
The Air Filter lamp will illuminate accompanied by
the non-critical alarm if the fault has existed for 0
seconds . Stop the tractor and service the air filter to
prevent engine damage .
8. Cold Start
The Cold Start lamp will illuminate when outside
temperature is at or below 0° C (32° F) .
Use the ether cold start to assist engine starting in
cold weather, (see page 3-5) .
9. Coolant Level Low
The Coolant Level lamp will illuminate when coolant
drops below the sender level . A critical alarm will
sound . Check for leaks and refill cooling system .
10. Alternator Charge Indicator
The Alternator lamp will illuminate steady if the
alternator is not charging the battery . The lamp will
flash and the non-critical alarm will sound if an
overcharge condition occurs .
11. Intercooler Overheated
The Intercooler lamp will illuminate and the non-
critical alarm will sound when an overheat condition
occurs . The cause of the alarm should be determined
and corrected before further operation or engine
damage may occur .
4 5 6 7
8 9 10 11
Section 3 - Operation
Electronic Instrument Cluster - EIC