Buhler 535 - Manual (Page 68)

435/485/535
3-39
F3-52
SPEED
PTO RPM AREA
START
STOP
OFF
ON
DIST FT
% SLIP
DISTANCE
SELECT
1 2 3
Section 3 - Operation
EIC - Tractor Performance Monitor (TPM)
F3-55
SPEED
PTO RPM AREA
START
STOP
HOUR
FUEL
GAL
% SLIP
DISTANCE
SELECT
AREA
F3-54
SPEED
PTO RPM AREA
START
STOP
% SLIP
DISTANCE
SELECT
Distance Measurement
Touch the SELECT button () again and the “DIST
FT” (2) or “DIST METERS” legend will be displayed .
The tractor will now measure distance in feet or
meters . Operate the tractor normally and press the
START/STOP button (3) at the point where distance
measuring is to begin . The “ON” legend (4) will be
displayed along with a digital display of distance
traveled (5) . At the end of the distance, again press the
START/STOP button (3) . A digital display of distance
traveled (5) in feet or meters will be displayed with the
“OFF” legend (6) . If the START/STOP button is again
pressed, additional feet or meters will be added to
the existing measurement . Pressing the START/STOP
button (3) for more than three seconds will zero the
display .
Cabin Temperature (Optional)
In tractors fitted with the automatic temperature
control system, cabin temperature can be displayed
by depressing the CABIN TEMP button (7) or by
toggling the SELECT button (8) . The “Ct” legend (9)
will display, together with temperature reading (0) .
Fuel Per Hour
Fuel per hour is displayed by toggling the SELECT
button () . The FUEL/HOUR legend (2) will display
together with rate of fuel consumption in liters or
gallons per hour (3) . (For switching between metric
and imperial see page 3-42) .
Fuel Per Area
Fuel per area is displayed by selecting fuel per hour
mode and then toggling the UP and DOWN arrow
buttons (4) . The fuel per area legend (5) will display
together with the related fuel consumption in liters or
gallons per hour/area .
9
7
8 10
4
5
6
11 13 15 12
14