Buhler 535 - Manual (Page 76)

435/485/535
3-47
F3-69
(SET) OFF
CRU
ISE
N
1
3
2
4
N
N
R
ON
STOP
F3-66
F3-63
N
R
ON
STOP
AUT O
Cruise Control Operation
Cruise control automatically keeps the engine speed
at a specified RPM . Two switches control cruise
mode operation . The “CRUISE/OFF” switch ()
enters and exits cruise mode . The “+/- (SET)” switch
(2) adjusts the cruise setting . When cruise mode is
activated, the engine returns to the last cruise
setting, if possible, based on throttle lever position .
PTO Engagement Switch - yellow (optional)
To engage the PTO depress the button (3) in the
center of the PTO engagement switch (4) and pull the
knob upwards . To disengage the PTO, push the knob
down .
CAT TA22 Transmission Autoshift Switch
(optional)
Press and release the front/symbol of autoshift
momentary switch (5) to engage the transmission auto
shift . The letter “A” will be displayed in the powershift
display when autoshift is engaged . Press and release
the switch again to disengage the autoshift function .
See page 3-64 for details of operation .
Differential Lock Switch (optional front & rear)
Press the front/symbol of differential lock switch
(6) to engage the self-holding differential . The DIFF
LOCK warning light will illuminate on the EIC when
the differential lock is engaged . Press the rear of the
switch to disengage . See page 3-66 for details of
operation . The differential lock will disengage if the
back part of the switch is depressed, if the foot brake
is applied or when ground speeds exceed 6 KPH (0
MPH) .
Remote Hydraulic Valve Controls - Manual
Note: See “Remote Control Valve Operation” on page
3-74 for details of operation before use.
Up to six remote hydraulic control levers (7) are
located on the right console . These are color-coded to
match the quick couplers at the rear of the tractor .
The levers have four positions: neutral, extend (or
raise), retract (or lower) and float, as indicated by the
decals . When not in use, the levers should be in the
neutral position where they can be locked to prevent
accidental actuation .
Lockout Levers - Manual
Below each control lever is a corresponding lockout
lever (8) to prevent or limit travel of the control lever .
See page 3-75 for details of operation.
1 2
4
3
5
7
8
Section 3 - Operation
Right Side Console Controls
6