JLG 450A_AJ Series II Service Manual - Manual (Page 341)

SECTION 6 - JLG CONTROL SYSTEM
3121180 – JLG Lift – 6-5
When a top level menu is selected, a new set of menu
items may be offered: for example:
DRIVE
BOOM
SYSTEM
DATALOG
VERSIONS
Pressing ENTER with any above displayed menus show
sub-menus within the selected menu. In some cases,
such as DRIVE, the next level is parameter or information
to be changed. Refer to flow chart for what menus are
available within top level menus. You may only view per-
sonality settings for selected menus while in access level
2. Remember, you may always cancel a selected menu
item by pressing the ESC. key.
6.4 CHANGING HAND HELD ANALYZER
ACCESS LEVEL
When analyzer is first connected, you will be in access
level 2 which enables you to only view most settings
which cannot be changed until you enter a password to
advance to a lower level. This ensures a setting cannot be
accidentally changed. Enter password to change access
level. To enter password, scroll to ACCESS LEVEL menu.
For example:
MENU:
ACCESS LEVEL 2
Press ENTER to select ACCESS LEVEL menu.
Using UP or DOWN arrow keys, enter first digit of pass-
word, 3.
Use RIGHT arrow key to position cursor right one space
to enter second digit of password.
Use UP or DOWN arrow key to enter second digit of pass-
word which is 33271.
Continue using arrow keys until all remaining digits of
password is shown.
Once correct password is displayed, press ENTER.
Access level displays the following if password was
entered correctly:
MENU:
ACCESS LEVEL 1
Repeat above steps if correct access level is not displayed
or you can not adjust personality settings.