JLG 450A_AJ Series II Service Manual - Manual (Page 92)

SECTION 3 - CHASSIS & TURNTABLE
3-42 – JLG Lift – 3121180
Tool List
The following specialized tools are used to assemble this
unit. Tool diagrams in this manual are intended for the
customer who may wish to have a tool made. All tools are
one piece and must be made from mild steel. All dimen-
sions are in inches.
NOTE: Tools may be carburized and hardened to improve
tool life. If this is done, tools must be ground on all
surfaces labeled with a “G” on the tool diagram.
1. T-118126 SEAL PRESSING TOOL FOR SEAL (1B).
2. T-138903 ASSEMBLY PRESSING TOOL FOR CUP (1C).
3. T-140433 ASSEMBLY PRESSING TOOL FOR CUP (1E) .
4. T-109691 ASSEMBLY PRESSING TOOL FOR CONE (1F).
* These tools are for specific seals, cups or cones. There
is a specific tool for each cup and cone.