Main assembly, Main assembly -37 – JLG 450A_AJ Series II Service Manual User Manual
Page 87
Advertising
SECTION 3 - CHASSIS & TURNTABLE
3121180
– JLG Lift –
3-37
9. Place spacer (1H) on spindle (1A) in hub (1G).
NOTE: Make sure retaining ring is securely seated in groove.
10. Place retaining ring (1I) over spacer onto spindle
(1A) in hub (1G).
11. At this point hub-spindle sub-assembly is complete.
Main Assembly
SHARP EDGES CAN CUT AND CAUSE SERIOUS INJURY. BEWARE
OF SHARP EDGES IN COUNTERBORE WHEN REMOVING O-RING.
1. Grease O-ring (5) and place it into counterbore in
hub (1G).
NOTE: O-ring may be stretched or pinched together to
make it fit into counterbore.
2. Oil exposed surfaces inside hub (1G).
Advertising