JLG 450A_AJ Series II Service Manual - Manual (Page 84)

SECTION 3 - CHASSIS & TURNTABLE
3-34 – JLG Lift – 3121180
Cover Sub-Assembly
1. Using disconnect rod, push O-ring (6F) into groove
inside cover cap (6B).
2. Place O-ring (6G) onto cover cap (6B) so it rests
against flange of cover cap.
3. Insert disconnect rod (6E) into cover cap (6B).
4. Set cover (6A) on table, exterior side up. Place cover
cap (6B) on cover (6A), aligning pipe plug hole in
cover cap over pipe plug hole in cover.
5. Place two cover cap bolts (6C) in any two bolt holes
180° apart on cover cap (6B) and tighten bolts.
6. Using a torque wrench, apply 36 to 49 in-lb (4 to 5 Nm)
of torque to both bolts (6C).