JLG 450A_AJ Series II Service Manual - Manual (Page 56)

SECTION 3 - CHASSIS & TURNTABLE
3-6 – JLG Lift – 3121180
Input Carrier Disassembly
1. Place Carrier (3A) on a press with spline end up.
Drive Planet Shaft (3E) out of Carrier (3A).
2. Slide Planet Gear (3F) and two Thrust Washers (3B)
out of Carrier (3A).
3. Remove 14 needle Bearings (3C) from bore of
Planet Gear (3F).
4. Repeat steps 1 through 3 for remaining planet
gears.
Figure 3-3. Input Carrier Disassembly
3A. Carrier
3B. Thrust Washers
3C. Needle Bearings
3E. Planet Shaft
3F. Planet Gear