JLG 450A_AJ Series II Service Manual User Manual

Page 394

Advertising
background image

SECTION 6 - JLG CONTROL SYSTEM

6-58

– JLG Lift –

3121180

3/2

Flash code 3/2 indicates that a contactor did not open when energized.
NOT REQUIRED

3/3

Flash code 3/3 indicates that a driver is short-circuit.

6

ADD DRIVER FAULTS

3/5

Flash code 3/5 indicates a brake pressure problem.
NOT REQUIRED

7

4/2

Flash code 4/2 indicates that the engine is over temperature. NOT REQUIRED

8

4/3

Flash code 4/3 indicates problems with the engine

9

ENGINE TEMP GREATER THAN
130C (266° F)

AIR FILTER BYPASSED

Air filter clogged

NO aLTERNATOR OUTPUT

The measured battery voltage is less than 12.5 VDC

OIL PRESSURE LESS THAN O.5
BAR (8PSI)

4/4

Flash code 4/4 indicates problems with the battery supply.

7

BATTERY LOW

Battery voltage is below 11V. This is a warning - the controller does
not shut down.

BATTERY TOO HIGH - SYSTEM
SHUT DOWN

Battery voltage is above 18V. EMS recycle required.

BATTERY TOO LOW - SYSTEM
SHUT DOWN

Battery voltage is below 6V. EMS recycle required.

5/5

Flash code 5/5 indicates problems with vehicle engine RPM or the encoder.

8

SPEED SENSOR READING
INVALID SPEED

Speed sensor is indicating an impossible number of pulses. This is
probably due to a faulty speed sensor.

SPEED INPUT LOST

Diesel engine speed input to system has been lost. This is probably
due to wiring problems at ground module or a faulty speed sensor.

ENGINE SPEED DOES NOT
MATCH COMMAND

Diesel engine governor has stuck. This is probably due to electrical
or mechanical problems with the governor.

6/6

Flash code 6/6 indicates problems with the CAN bus.

10

CAN BUS FAILURE:

Ground module or platform module not receiving. This is probably
due to wiring problems between platform and ground modules.

7/7

Flash code 7/7 indicates problems with a motor.
NOT REQUIRED

9/9

Flash code 9/9 indicates problems with the controller.

11

PLATFORM MODULE FAILURE:
hwfs CODE 1

Platform module V(Low) FET has failed

GROUND MODULE FAILURE:
hwfs CODE 1

Ground module V(Low) FET has failed

Table 6-7. Help Fault Codes, Displayed Faults, and Descriptions - Prior to S/N 0300066949

Advertising