JLG 450A_AJ Series II Service Manual - Manual (Page 88)

SECTION 3 - CHASSIS & TURNTABLE
3-38 – JLG Lift – 3121180
3. Place internal gear (2) in hub (1G) so its internal
splines mesh with external splines of spindle (1A).
Oil internal gear (2).
4. Place thrust washer (11) around spindle (1A) so it
rests on bottom of internal gear (2).
5. Stand input shaft (7A) on splined end. Place one
spacer (7D) on smooth end of input shaft (7A).
6. Place spring (7C) on smooth end of input shaft (7A).
7. Place other spacer (7D) on smooth end of input
shaft (7A).
UNCONTROLLED OBJECTS CAN CAUSE EYE DAMAGE OR SERI-
OUS INJURY. ALWAYS WEAR EYE PROTECTION.
8. Using retaining ring pliers, insert retaining ring (7B)
in groove on input shaft (7A) by compressing spring
and spacers together.