JLG 450A_AJ Series II Service Manual - Manual (Page 387)

SECTION 6 - JLG CONTROL SYSTEM
3121180 – JLG Lift – 6-51
osc axle p sw OP/CL Oscillating axle pressure switch status. (Displayed if
OSCILLATING AXLE = 1)
sky welder YES/NO Status of Sky Welder selected during boom sensor calibration.
(Displayed if MODEL NUMBER = 7 or 8)
sky cutter YES/NO Status of Sky Cutter status selected during boom sensor calibra-
tion. (Displayed if MODEL NUMBER = 7 or 8)
sky glazier YES/NO Status of Sky Glazier selected during boom sensor calibration.
(Displayed if MODEL NUMBER = 7 or 8)
sky Bright YES/NO Status of Sky Bright selected during boom sensor calibration.
(Displayed if MODEL NUMBER = 7 or 8)
Pipe Racks YES/NO Status of Pipe Racks selected during boom sensor calibration.
(Displayed if MODEL NUMBER = 7 or 8)
Camera mount YES/NO Status of Camera Mount selected during boom sensor calibra-
tion. (Displayed if MODEL NUMBER = 7 or 8)
LOAD: Not displayed if LOAD=NO, LENGTH=NO, and ANGLE=NO
(machine digits = 0)
LENGTH OP /CL Measured length, Not displayed if MODEL NUMBER = 7 or 8
ANGLE OP / CL Measured angle, Not displayed if MODEL NUMBER = 7 or 8
WEIGHT XXXX% Percentage of maximum calibrated weight on the platform. An
uncalibrated load cell reads 1000% Displayed if LOAD is not 0 and
LOAD TYPE is 0.
OK/OVERLOADED LSS system status. Displayed if LOAD is not 0 and LOAD TYPE is
1.
Table 6-6. Machine Diagnostics Parameters
Diagnostics
Submenu
(Displayed on
Analyzer 1
st
Line)
Parameter (Displayed
on Analyzer 2
nd
Line)
Parameter Value
(Displayed on Analyzer 2 nd
Line)
Description