2N PBX 2N NetStar - Configuration Manual v2.6.0 - Manual (Page 10)

Configuration menu 1.4
10
Figure 5 View of the dialogue of connection course.
If you aren't able to connect to your PbX, please check following:
1) PbX is switched on;
2) PbX is connected to the network;
3) both sides have the same IP address and port;
4) used communication port is opened;
5) you are using corresponding versions of firmware and configuration tool;
6) used communication port isn't blocked by your antivirus software;
1.4 Configuration menu
Main menu
After succesful connection to the PbX is displayed configuration part of the application. Main menu of
this view is shown on the figure 1 and it contains following options:
Administrator
Logout PbX – With this option you can logout configuration tool from PbX and return to the previous
menu where you can choose another connection. Connect/Disconnect – These options are used only
in the offline mode. You can use them for connecting and disconnecting configuration tool to the PbX.
Save changes – With this option you can save all changes made since last save. Undo changes –
With this option you can cancel all changes made since last save within concrete menu.
Settings – With this option you can invoke dialogue for global settings of the configuration tool, which
was described in the chapter 1.2 in the part Global settings of the configuration tool.
Language – Here you can choose one of supported languages.