2N PBX 2N NetStar - Configuration Manual v2.6.0 - Manual (Page 28)

ASL virtual port 3.3
28
Figure 1 View of hardware configuration for ASL virtual port.
Line parameters
Impedance – This parameter determines impedance of the hybrid according to preset models (User,
ETSI 600, Germany and Real 600).
Line model – This parameter determines another parameters of the hybrid according to preset
models EIA0 to EIA7 (e.g. EIA0 represents model of 100m long line).
Signalling type – Type of signalling of Active state. You can choose between Reverse polarity, Tarif
pulse or Simple.
Tariff pulse type – It defines source for tariff pulse sending. You can choose between 12 kHz, 16
kHz or none.
Incoming parameters (dialing from phone)
Call type – Parameter determines prefered type of communication on this carrier. You can choose
between Voice, FAX, A3,1kHz Audio and 56kb Modem.
DTMF dialling enabled – When it is checked, carrier is able to detect DTMF dialing from analog
phone.
Pulse dialling enabled – When it is checked, carrier is able to detect pulse dialing from analog
phone.
FLASH length [ms] – Parameter sets the maximum time of the FLASH transmitted from the local
phone to the PbX. Default duration is set to 150 ms. Minimum of this parameter is on 80 ms.
Disable port DTMF detection – With this parameter you can enable DTMF detection using detector
on the board. Otherwise is detection executed by internal detectors. Number of detectors is limited
and this way you can save them for ports without this possibility.
Outgoing parameters (phone rings)
CLI broadcasting mode – Parameter defines prefered method of CLI presentation (Calling Party
Number) transmission. You can choose between DTMF, FSK or none.