2N PBX 2N NetStar - Configuration Manual v2.6.0 - Manual (Page 115)

Setting the properties tab 9.1
115
delay).
Identification parameters
Incoming hold CLIP – This parameter is used for called party number forwarding to the called user
in the case of call transfer made by station where is this parameter enabled. It means, that if it is set
to "YES", transferred call will be identified by the calling number of transferred user (A) and not with
the called party number of the user who transferred (B). Default value of this parameter is "NO".
Outgoing hold CLIP – This parameter is used for displaying of the original calling party number in
the case of transferred call. It means, that if it is set to "YES", you will see calling party number of
transferred user (A) and not called party number of the user who transferred the call (B). Default
value of this parameter is "NO".
Use default number – With this parameter you can replace part of the preset identification
(specified by the identification tab) with own identification of the calling station. Default value of this
parameter i "YES" (replacing is enabled). This parameter you can find only on the carries and carrier
types!
Language – With this option you can set up the language for StarPoint terminals. You can choose
one of the languages from the list. Default value of this option corresponds to the preset localization
of the PbX.
Max. user tel. nums – This parameter sets maximum count of records within the user private phone
book. This parameter you can find only on the user level! Default value of this parameter is 10
records.
b) Routing
To port – With this option you can set up routing of the outgoing call through this port. Outgoing
means the direction outwards from the PbX.
From port – With this option you can set up routing of the incoming calls. Incoming means direction
inwards to the PbX.
Autoclip parameters for call – With this option you can choose autoclip parameters set for storing
of autoclip router records. This option can be used only on the level of user profile, user and group.
No port – With this option you can set up routing for stations without port (they aren't assigned to
the carrier). It is used above all for external stations and virtual stations, which can be used for
special cases of routing. This setting you can find only on the carrier and carrier type level.
More information about calls and SMS routing you can find in the chapter 7.1 Routers.
c) ME
The tab ME is used for setting up of specific parameters generally used for external station. At all
there are parameters for call holding from the external station. Mobile phones haven't key for call
holding within the PbX and that is why this function has to be compensate. This tab contains following
parameters:
Transfer – With this parameter you can enable call holding from external station. This function is
under license. If you set up this parameter on the user level, you will need as many stations as this
user has stations (external station isn't counted, because it need license for using).
Pattern timeout [ms] – With this parameter you can set up timeout between individual characters
of FLASH and DISCONNECT pattern. This timeout is important for correct recognition of the pattern.
If the delay between individual characters of the pattern is longer than preset timeout, pattern is not
recognized.
FLASH pattern – With this parameter you can set up characters of the FLASH pattern. This pattern