2N PBX 2N NetStar - Configuration Manual v2.6.0 - Manual (Page 32)

GSM virtual port 3.5
32
Figure 1 View of hardware configuration for GSM virtual port.
GSM interface parameters
Hide number – This checkbox enables calling with suppressed calling party number (CLIR – Calling
Line Identification Restriction). This function must be supported by the network (by the operator).
Otherwise calls with suppressed identification are refused with corresponding cause.
Relax timeout between calls – This parameter determines the idle period between two calls. It
concerns only calls going out from the PbX through GSM carrier, not the incoming calls. During this
time are all outgoing calls refused with the cause 34 – no circuit/channel available.
DID transmission in number – With this parameter you can enable special function of transmission
number for direct dialling within called number. This function is supported only in some networks.
DID separator – With this character is separated called number of the SIM card and DID number
(number for direct dialling).
Diasable port DTMF detection – With this parameter you can enable DTMF detection using detector
on the board. Otherwise is detection executed by internal detectors. Number of detectors is limited
and this way you can save them for ports without this possibility.
GSM modul diagnostic
Producer – Information about board manufacturer.
Type – Information about type of the board.
Firmware revision – This field shows software revision of firmware which is uploaded into the
board.