2N PBX 2N NetStar - Configuration Manual v2.6.0 - Manual (Page 81)

Routing objects 7.2
81
Figure 2 View of configuration menu of routing object Bundle – tab Advanced.
7.2.4 Ring tabs
Ring tab
The ring tab in a routing object, which is used in the cases when you want to route incoming call
subsequently to more destinations. It combines advantages of bundle and ring group. Routing of the
incoming call is handled according to the preset rules, which are always executed from the beginning.
If incoming call is accepted by any destination where it is currently routed, another routing according
to this ring tab is terminated.
Ring tab setting
The ring tab you can set up in the menu Routing – Routing objects – Ring tabs . On the left side
of the menu is displayed list of the created ring tabs. Via context menu you can ring tabs add, delete
or rename. If you choose one of the ring tabs, you can set up its parameters on the right side of this
menu.
This menu consists of many parameters with following meaning:
Default alert tones – Within this section you can set up different alert tones for specific situations.
Normal – It sets alert tone which is used at all cases except following two.
Queued – It sets alert tone, which is used by routing to the station in the case that you use
the command:
Route with queue – Selected alert tone is used regardless of the setting