2N NetStar Admin manual - Manual (Page 107)

107
6.2 Emergency Calls
This menu helps you route emergency calls properly when the PBX is in one of
the pre–defined emergency modes. Of course, this setting does not solve the PBX
error states. In error states, analog CO lines and an analog telephone connected to the
corresponding port of the same card can be used, for example. If the card is not
powered, these ports are disconnected and you can make PSTN calls via the card
directly.
List of emergency numbers – here specify all necessary emergency numbers.
Enter the numbers into one row using the comma separator. The count of
numbers is unlimited.
Set exceptional situations – define how the PBX should process calls other
than the emergency ones. A call rejection cause and a voice message are defined
for each contingency.
Licence expired – the PBX licence has expired.
Emergency mode – PBX emergency mode.
Disable calls
– the Disable new calls option from the Global parameters
menu has been activated. No new calls may be set up but active calls are
not terminated (the PBX is waiting for the users to hang up).
Destination for emergency calls – define a virtual port or bundle of ports to
be used for emergency call routing.
Figure: View of Possible Emergency Call Menu Configuration