2N NetStar Admin manual - Manual (Page 124)

124
6.9 Ring Tones
To set the ringing tones use the menu. Each ringing Global Data – Ring Patterns
tone consists of a ring pattern and Cornet tune. Some terminals are unable to change
the ring tune and use the ring pattern only. See a list of available ring patterns on the
left. You can add, remove or rename the ring patterns using the context menu. During
database creation, default progress tone patterns are created that can be edited or
removed as necessary. To restore the default settings without removing the tones
created by you, use the
option. To restore the default settings and remove all Update
the ring tones, use the option in the context menu. To create the ring tones, Default
use the following parameters:
Figure: View of Ring Tone Configuration Menu
Repeat – check this option to make a tone pattern being played repeatedly. If
this option is not checked, the tone pattern is used only once.
Cornet tune – use this parameter to assign a ring tone tune to a selected ring
pattern in the StarPoint key telephones.
BRI signal – use this parameter to set the ring tone signalling for the ISDN
terminals that support multi–tune ringing.
Delay – here set the ring pattern using two columns and four rows. Set the ON
and
columns for each row to be used. represents the ring current time OFF ON
and represents the row resumption delay. Both the parameters are set in OFF
milliseconds.