2N NetStar Admin manual - Manual (Page 274)

274
To apply your new configuration, save the changes to NetStar using the saving icon (or
Ctrl+S). To configure the interface into the TE mode, take the same steps and set the
jumpers and interface mode to TE.
BRI ISDN
The most impotant aspect of BRI interface configuring is the configuration of the BRI
line between the NetStar and PBX systems. The first information we need is the BRI
interface configuration on the PBX. In case you are not sure about the PBX BRI port
configuration, contact a person responsible for the PBX maintenance without delay. In
our case, the PBX was connected to the PSTN and so the BRI port is configured as TE
and Point-to-Point. For correct interconnection, NetStar has to be configured as NT and
also PTP. To do so you have to:
Set BRI card jumpers – to do so switch NetStar into service mode. When the
light goes off on the BRI card, remove the card from the rack and check the
jumper configuration. For a correct jumper placing use the sticker on the BRI
port.
Set correct communication protocol in the NetStar configuration tool. To do
so go to the
menu in and choose the port to be configured. Boards Hardware