2N NetStar Admin manual - Manual (Page 170)

170
Figure: Příklad konfigurace objektu DISA se strategií Ihned
The menu consists of the following parameters:
Tone – use this option to choose a suitable progress tone from the list. Add
progress tones and messages of your own in the menu in Chapter 6.7, Progress
tones, if desired.
Destination after DTMF dial – use this option to set a router to be used for call
routing by the PBX upon DTMF dialling.
DTMF – use this option to set whether the DTMF detector should be
allocated for the DISA. The count of DTMF detectors is determined by the
available hardware profile. If you do not select this option, the following
three parameters are not available for configuration.
Timeout [s] – set how long the DISA object should wait for DTMF. If you
select , the whole voice message will be played back and the call will be
0
routed to the default destination. Therefore, never choose the endless
in the parameter in this case. voice message Tone
Type – set the router type for call routing.
Id – choose a router of the selected type.
Default Destination – set an object for call routing if no DTMF dialling is
detected within the timeout.
Type – set the destination type for call routing.
Id – choose a destination of the selected type.